logo-invert
Can't find the right part? Why not try our engine number search
This site uses and sets "cookies" on your computer to help make this website better. You can learn more about these cookies and general information about how to change your cookie settings by visiting our privacy and cookies page. By continuing to use this site without changing your settings, you are agreeing to our use of cookies.  Click close to remove this notification. Privacy and cookie policy

2 cylinder engines

55 results Refine Results

Glow plug | 185366250

Glow plugs provide in-cylinder heating to aid diesel engine starting in cold weather, reducing the cranking time to start the engine. Designed for use in heavy-duty diesel engines with short heat up time and long service life.
£26.46

Excl. VAT £22.05

£26.46

Excl. VAT £22.05

Rear oil seal | 198636080

Rear end oil seal 198636080 for engine crankshaft, engineered to ensure a perfect seal, maximum contamination exclusion and deliver a long lifetime of load endurance and seal efficiency.
£26.64

Excl. VAT £22.20

£26.64

Excl. VAT £22.20

Pre-fuel filter | 130306360

Filters or strainers designed to be installed on the inlet side of the fuel pump to remove the debris that could damage the fuel pump, but not cause a reduction in pressure that could lead to cavitation and damage to the fuel pump. These filters have larger micron ratings than the main or secondary fuel filter.
£7.44

Excl. VAT £6.20

£7.44

Excl. VAT £6.20

Pre-fuel filter | 130366040

Filters or strainers designed to be installed on the inlet side of the fuel pump to remove the debris that could damage the fuel pump, but not cause a reduction in pressure that could lead to cavitation and damage to the fuel pump. These filters have larger micron ratings than the main or secondary fuel filter.
£7.44

Excl. VAT £6.20

£7.44

Excl. VAT £6.20

Timing case cover gasket | 165996500

The timing case cover gasket 165996500 is the working seal between the timing cover and the engine block, preventing contaminants out of the gear shaft area and ensuring an effective fluid seal, where symptoms of wear or failure include an oil or coolant leak. Every gasket is the same as used on genuine manufacturing and designed to ensure a perfect fit and effective sealing. When the timing cover is removed to correct a leak, the timing components should be thoroughly inspected and replaced, if necessary.
£8.88

Excl. VAT £7.40

£8.88

Excl. VAT £7.40

Front oil seal | 198636090

Front end oil seal for engine crankshaft, engineered to ensure a perfect seal, maximum contamination exclusion and deliver a long lifetime of load endurance and seal efficiency.
£6.12

Excl. VAT £5.10

£6.12

Excl. VAT £5.10

Exhaust elbow gasket | T415605

Exhaust to turbocharger exhaust supply gasket T415605, designed and manufactured for a long and reliable life.
£1.62

Excl. VAT £1.35

£1.62

Excl. VAT £1.35

Water pump pulley | 145336490

Solid water pump pulley 145336490 designed for your engine to ensure correct water circulation and engine cooling. Differences in pulley size can lead to overheating and engine strain. Exactly the same pulley as fitted to the genuine engine, making it easy to fit with the correct shaft and fitting dimensions.
£24.54

Excl. VAT £20.45

£24.54

Excl. VAT £20.45

Oil filter | 140517030

Spin on oil filter 140517030 for Perkins engines, designed to meet the needs of Perkins engines by providing superior protection against particles that can make their way into the lubrication system during service or from component wear. Increasing emissions levels has resulted in more precise engineering tolerances in galleries and channels leaving less room between engine components than before, so choosing a genuine Perkins filter is more important than ever to ensure effective lubrication and cooling. Designed to reduce resistance to oil flow while maximizing filter efficiency and provide protection to the recommended oil service interval in the Operation and Maintenance Manual. Typically fitted with anti-drain back valve and by-pass valve to ensure the engine oil is in the right place during starting and operation. Supplied complete with sealing ring.
£5.10

Excl. VAT £4.25

£5.10

Excl. VAT £4.25

Water temperature sensor | 385720500

The water or coolant temperature sensor 385720500 is used to measure the temperature of the engine coolant, which can then be fed back to the ECU, to adjust the fuel ignition and timing. Helping to ensure more fuel is supplied when the engine is cold or less when the engine is warm. Alternatively, some engines may use this as an indicator to switch on an electric fan or provide a reading for a dashboard readout. Temperature plays a vital role in engine performance calculations; a sensor failure can quickly lead to issues such as; poor fuel economy, black smoke or overheating. Perkins temperature sensors are carefully selected to they are durable and reliable to give your engine long, productive life.
£37.86

Excl. VAT £31.55

£37.86

Excl. VAT £31.55

Lift pump | 130506140

Primary fuel pump to move the fuel from the tank into the engine fuel system. Designed to ensure the correct level of flow and pressure into the fuel system, correct flow rate and pressure are critical to prevent the issues of cavitation and vaporisation that can lead to implosion and damage to surfaces. Perkins fuel pumps are carefully selected during our engine design to provide the pressure and flow required for the whole fuel system and tested for many thousands of running hours to ensure smooth running and maximum performance and power. Uses high-performance seals to ensure long life, and deliver correct pressure whatever the conditions.
£36.96

Excl. VAT £30.80

£36.96

Excl. VAT £30.80

Water pump | 145017380

Water pump 145017380 is a simple centrifugal pump, pushing the fluid from the pump into the engine, often belt driven from the crankshaft to circulate coolant fluid whenever the engine is running. Common signs of wear include coolant leaks, overheating of the engine, the pulley is loose and making whining sounds, or worst case steam coming from the engine. Perkins water pumps undergo extensive testing to ensure coolant flow and pressures match the engine requirements, and are designed to meet the flow and pressures within the engine using high-quality ceramic cartridge seals and sealed bearings. Typically Perkins water pumps are supplied with fitting kits.
£186.48

Excl. VAT £155.40

£186.48

Excl. VAT £155.40

Oil pressure sensor | 185246060

Oil pressure sensors 185246060 within the engine can be used to provide a visible warning to the operator when oil levels are low and are designed to assist in engine control. Without the proper amount of oil, your engine will sustain major damage. Calibrated to the oil pressure the engine requires for effective oil circulation.
£10.02

Excl. VAT £8.35

£10.02

Excl. VAT £8.35

Alternator | 185046210

All Perkins alternators 185046210have been specifically designed to work with the speed and power of your engine, to ensure a long and durable life, and tested for thousands of hours on an engine to maximise operating life and ensure durability. As we use the latest technology components, you can be sure of performance and reliability and are the same parts supplied with your genuine engine. Perkins alternators are designed to fit on our engines, with mountings in the same place and orientation as on the genuine engine, making replacement an easier task. A non-genuine alternator may not have the power to keep up with all of your machines electrical requirements and may not have the mounting/fittings making replacement harder and weakening performance and lifetime. Repaired or rewound electrical parts may not have the durability of a new genuine part, and can cause early failures from poor quality internal brushes and bearings.
£170.22

Excl. VAT £141.85

£170.22

Excl. VAT £141.85

Dipstick | 198416861

Enables checking of the oil level within the engine using the dipstick 198416861, includes a seal to prevent the oil becoming contaminated. Depending on the design of the engine, application engine models and sump volume require different design of dipstick, so it is important to have the right length of dipstick and position. Coloured handle for easy to read level indicator and easy recognition. Remember to let the oil settle with the engine off, on level ground for 5 to 10 minutes before checking the oil level. Overfilling is as bad as under filling, always maintain the oil level according to the Perkins Operation and Maintenance Manual.
£5.76

Excl. VAT £4.80

£5.76

Excl. VAT £4.80

Timing case throttle lever gasket | U65996640

Mounting gasket 36861466 for the throttle lever assembly to the timing case, designed and manufactured for a long and reliable life.
£0.72

Excl. VAT £0.60

£0.72

Excl. VAT £0.60

Close